How to Apply Decal Stickers to Your Car

These recommendations will help you install your new decals. If you're new to this, we highly recommend professional installation. We can't offer replacements or refunds for improper installation or use.

Important Considerations:

  • Keep it Dry: Don't get your new decals wet for at least 48 hours after installation. This helps the adhesive cure properly.

  • Wiper Blades: Avoid using your wiper blades over the decal until it's fully cured.

  • Temperature Matters: Only install your decals when the temperature is between 10°C (59°F) and 25°C (77°F). This is crucial for proper adhesion.

Step 1: Clean the Surface

Thoroughly clean the area where the decal will go.

  • Remove all dirt, grease, and residue.

  • Wipe with rubbing alcohol and a clean microfiber cloth to remove waxes or protectants. Dish soap and hot water can work too, but rinse thoroughly.

  • Avoid glass cleaners (they often leave residue).

  • Make sure the surface is completely dry before moving on. You can use a hairdryer to speed this up, but let it cool.

Step 2: Prepare the Decal

Get your decal ready for application.

  • Lay the decal face-up on a flat, stable surface.

  • Rub firmly across the decal with a squeegee (or a microfiber cloth and your hand) to press the transfer tape onto the vinyl.

  • Use moderate pressure to avoid damaging the tape.

Step 3: Optional - Position Your Decal

Measure and mark the placement of your decal if you want to be precise.

  • Use a ruler to determine the exact spot.

  • Lightly secure it with masking tape.

  • Double-check your measurements before proceeding.

Step 4: Separate the Backing

Carefully peel the decal from its paper backing.

  • Slowly peel the paper backing away.

  • If the decal sticks to the backing, gently press it back down and re-rub that area (from Step 2).

  • You want the transfer tape to lift the entire decal in one piece. Take your time!

  • Peeling at a 45-degree angle often works best.

Step 5: Apply Your Decal

Now, apply the decal to your prepared surface.

  • Place the decal onto the surface.

  • Starting from the center and working outwards, firmly press the decal down with your squeegee or cloth.

  • Push out any air bubbles towards the edges (you can use a small pin for larger bubbles later).

  • Wait 10-15 minutes for the decal to adhere well.

  • Don't press too hard. Use your fingers for precise areas.

Step 6: Remove the Transfer Tape

Carefully peel off the top transfer tape.

  • Slowly peel the transfer tape off at a shallow 45-degree angle.

  • If any part of the decal lifts, stop, press it back down, and continue peeling very slowly.

  • Once the tape is off, firmly press down on the entire decal with a microfiber cloth to ensure it's fully adhered.

Your ride now has a Happy Endings (or several)!! Welcome to the family.